NTSC Game Cube RGB Cable (continued)
Soldering the digital wires is just as easy, the Red wire goes to pin 15, Red ground - Pin 13, Green - Pin 11, Green ground - Pin 9, Blue - Pin 7, Blue Ground - Pin 5.
We need two more wires to complete the Scart plug, first solder the thin black wire to pin 8, this will be used to carry 12 volts which will switch your TV into AV mode.
Secondly, insulate the shielding wires which we twisted together earlier (mmmonkey would have insulated it earlier if he remembered), again we use heat shrink tubing, then solder it to pin 21. Depending on your Scart plug you may not have pin 21, it's actually the metal surround around the plug, you may have a pin attached, or maybe just a hole.
That's the Scart plug end finished, test it fits into the plug and that it holds the cables securely, mmmonkey had to add some tape to the cables so that it was a good fit.
